TEPLOSTAR Binar-5B-Compact, Руководство пользователя

Страница: 41 / 74

Binar-5B/5D-Compact ENG
3 Safety measures.
3.1. The pre-heater and its components shall be installed only by authorized
companies by reason of it complicated structure: there’s a combustion chamber (where
fuel burns), a heat exchanger (which provides heat transfer to the cooling liquid),pump,
fuel pump, air pump, control unit (which control and operate the work of the heater
according to the program), heat sensors, control panel, etc.
3.2. While installation or dismantling the pre-heater, safety measures specified for
activities with car wiring harness and fuel supply line must be observed.
3.3. The pre-heater shall be used only for purposes described in the present user
manual.
3.4. It is prohibited to lay the fuel pipe inside the passenger compartment or
driver’s cab.
3.5. It is prohibited to use the pre-heater in case of leaky fuel system.
3.6. Vehicle with the pre-heater shall be equipped with a fire extinguisher.
3.7. To avoid possibility of poisoning with the toxic exhaust gas generated by the
operating pre-heater, the exhaust pipe shall be set in a manner preventing discharge gas
ingress into the driver’s cab or its intake by the heat exchanger fan.
3.8. To avoid possibility of poisoning with the toxic exhaust gas generated by the
operating pre-heater, it is prohibited to use the pre-heater in enclosed car parks having no
ventilation (garage, workshop and etc.)
3.9. It is prohibited to use the pre-heater in areas, where highly inflammable vapors
or ample quantity of dust may be generated or accumulated.
3.10. While fueling the truck the pre-heater shall be switched o f f .
3.11.
It is prohibited to use battery master switch in the pre-heater electric
circuit.
3.12. The pre-heater shall be disconnected from the accumulator battery when
welding is performed with the vehicle.
3.13. It is prohibited to connect the pre-heater to the electric circuit of the vehicle
with the engine running and accumulator battery missing.
3.14. It is prohibited to switch off pre-heater power before ending of the
purging cycle.
3.15. It is prohibited to connect and disconnect the pre-heater plug when the pre­
heater power is on.
3.16. It is recommended to restart the pre-heater after it’s switching off not earlier
than in 5-10 sec.
3.17. In case of malfunctioning, the pre-heater shall be repaired in service centers,
authorized by the manufacturer.
5