IB 340515 (4-02)
1
No. 340515
Machine: ATLV
t
t
t
t
4300
Published: 4-02
Rev. 00
INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts
List in the appropriate place in your machine manual for future reference.
Retaining the Parts List will make it easier to reorder individual parts and will
save you the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for
kit number 368660
DESCRIPTION:
This kit contains the parts needed to install a broom holder on the model ATLV
t
4300 Litter
Vacuum.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1 hour)
PREPARATION:
(Refer to FIG. 1)
1. Stop the machine on a clean, level working surface and set the parking brake. Turn off the
machine and remove the key.
FOR SAFETY: Before leaving or servicing machine, stop on level surface and set parking
brake. Then turn off machine and remove key.
INSTALLATION:
(Refer to FIG. 1)
1. Position the new broom holder bracket (1) in place on the right rear fender of the machine.
2. Using the broom holder bracket (1) as a template, mark and drill two 9 mm (11/32)
diameter holes in the fender.
3. Secure the new broom holder bracket (1) to the fender with two hex screws (2), flat
washers (3) and two hex nuts (4).
TENNANT COMPANY
P. O. Box 1452
Minneapolis, MN 55440--1452
