P a g e
|
15
TEMELSAN MAKİNA SAN. VE TİC. LTD. ŞTİ.
Akçaburgaz Mah. Muhsin Yazıcıoğlu Cad. No:55/1
Esenyurt
/ İstanbul / TÜRKİYE
TEL: +90 (212) 544-2518 FAX: +90 (212) 577-6557 www.temelsan.com [email protected]
START-UP THE MACHINE
(Very important to follow step by step, do not proceed to next step when check point is not
confirmed for proper functionality)
1.
Turn the main power switch to
ON
2.
Check and unlock the Emergency Stop Button (to unlock turn on Button to left side)
3.
Press the
“BLUE RESET BUTTON”
to start the machine.
4.
Press the
“PROGRAM SELLECTION BUTTON”
and use
“(+) or (-) VALUE ADJUSTMENT
BUTTONS
”
to find your program and press the
“SET BUTTON”
5.
Press the
“BANDSAW SELLECTION BUTTON”
and use
“(+) or (-) VALUE ADJUSTMENT
BUTTONS”
to find your band saw type and press the
“SET BUTTON”
6.
Press the
“WELDING CURRENT SELLECTION BUTTON”
and use
“(+) or (-) VALUE
ADJUSTMENT BUTTONS”
to find your current value and press the
“SET BUTTON”
7.
Press the
“ANNEALING CURRENT SELLECTION BUTTON”
and use
“(+) or (-) VALUE
ADJUSTMENT BUTTONS”
to find your current value and press the
“SET BUTTON”
8.
Press the
“ANNEALING TIMER SELLECTION BUTTON”
and use
“(+) or (-) VALUE
ADJUSTMENT BUTTONS”
to find your timer value and press the
“SET BUTTON”
9.
Choice your annealing space and press the button
“WIDE ANNEALING”
or
“NARROW
ANNEALING”
button to set it.
10.
Push on Operator Keyboard the Button "
WELDING READY
" The right jaw should move on
position
11.
Check the space between the Jaws; it should be same as on indicator
12.
Push on Operator Keyboard the Button "Annealing Ready"
Congratulation, your Machine is correct connected and is ready to Calibrate several
following equipment
a.
Stopper Positions
b.
Jaw Level and spacing
