Instructions for use and maintenance
Electric motors 50-400 V CA
Page
9
of
22
7)
Adequate ventilation shall be ensured, avoiding bottlenecks in air passages and the entry
of swarf, dust or liquids and all cases that compromise the smooth operation of the motor
and/or heat disposal.
In case the motor to be installed is in version B3, that is equipped with feet for fixing, proceed
as described:
-
Make sure that the motor rests on a flat surface then secure each hole on the foot using
appropriate screws.
-
In the case of a flange-mounted motor, perform the following operations:
-
Check that the coupling flange is of the same size and design as that of the motor.
-
Clean the flange contact areas, remove the protection on the driveshaft and ensure that
the key is in the correct position.
-
Perform the coupling between the motor and the transmission gear taking care to tighten
all the screws on the flange holes.
WARNING:
-
The user is responsible for compliance with local regulations regarding
safety, installation and use.
-
All transportation, installation, use, ordinary and extraordinary
maintenance of the motor must be carried out exclusively by specialised
and competent operators.
-
Operator means the person or persons responsible for installing,
operating, adjusting, repairing and transporting the motor.
