14
Safety information
This message contains information on how to operate FMB640
safely. By following these requirements and recommendations,
you will avoid dangerous situations. You must read these
instructions carefully and follow them strictly before operating the
device!
•
The device uses SELV limited power source. The nominal
voltage is +12 V DC. The allowed voltage range is +12..+24 V DC.
•
To avoid mechanical damage, it is advised to transport the
device in an impact-proof package. Before usage, the device
should be placed so that its LED indicators are visible. They
show the status of device operation.
•
When connecting the 2x10 connector cables to the vehicle, the
appropriate jumpers of the power supply of the vehicle should
be disconnected.
•
Before dismounting the device from the vehicle, the 2x10
connector must be disconnected.
•
The device is designed to be mounted in a zone of limited
access, which is inaccessible to the operator. All related devices
must meet the requirements of EN 60950-1 standard.
•
The device FMB640 is not designed as a navigational device for
boats.
Do not disassemble the device. If the device is
damaged, the power supply cables are not
isolated
or the isolation is damaged, DO NOT
touch the device before unplugging the power
supply.
All wireless data transferring devices produce
interference that may affect other devices which
are placed nearby.
The device must be connected only by qualified
personnel.
The device must be firmly fastened in a
predefined location.
The programming must be performed using a PC
with autonomic power supply.
Installation and/or handling during a lightning
storm is prohibited.
The device is susceptible to water and humidity.
