Telsa TS-2BTM658-DIX, Инструкция пользователя

Страница: 28 / 58

EN -28-
Important Notes:
• In the case of a power failure, or if the appliance is unplugged and plugged in again, the
gas in the cooling system of your refrigerator will destabilise, causing the compressor
protective thermal element to open. Your refrigerator will start to operate normally after
5 minutes.
• If the appliance will not be used for a long period of time (such as during holidays),
disconnect the plug. Defrost and clean the refrigerator, leaving the door open to prevent
the formation of mildew and odour.
• If the problem persists after you have followed all the instructions above, please consult
the nearest Authorised Service Centre.
• This appliance is designed for domestic use and for the stated purposes only. It is not
suitable for commercial or common use. If the consumer uses the appliance in a way
that does not comply with these instructions, we emphasise that the manufacturer and
the dealer will not be responsible for any repair or failure within the guarantee period.
Tips for saving energy
1– Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near
heat sources (radiator, cooker.. etc. ). If you install it near heat sources, use an insulating
plate.
2– Allow warm food and drinks to cool down before putting them in the refrigerator or freezer
compartment.
3– When thawing frozen food, place it in the refrigerator compartment. The low temperature of
the frozen food will help to cool the refrigerator compartment while it is thawing, reducing
the energy required.
4– When placing liquids in the appliance, make sure they are covered. Otherwise humidity
increases inside the appliance and the time taken to cool them is longer. Also covering
drinks and liquids helps preserve the smell and taste.
5– When placing food and drinks in the appliance, open and close the appliance door as
quickly as possible to keep the temperature inside the appliance stable.
6– Keep the covers closed of any compartments with different temperature requirements in
the appliance (crisper, chiller ...etc. ).
7– Make sure the door gasket is clean and pliable. In case of wear, if your gasket is detachable,
replace the gasket. If not detachable, you have to replace the door.