Telpar MTP-1530II, Руководство пользователя

Страница: 38 / 83

Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (Revision 20120510) Page 38
4.4.5 Top of Form Commands
Top of Form Commands
Name Command
ASCII
Command
+n = data
byte[hex]
Description
Form feed FF 0C Print if needed then feed paper to the
next Black Mark if the BM sensor is
enabled. See GS ( F, GS FF, and
DSW1 position 1).
Feed to
Black Mark GS FF 1D 0C Feed paper to the next Black Mark
position. Ignored unless enabled by
Dip SW 1 position 1. See GS ( F, FF)
and Dip Switch settings.
Top of Form Commands
For additional information black mark sensing, see Section 2.2.2 Black
Mark Sensors Load.
4.4.6 Page Mode Commands
Bar Code Commands
Name Command
ASCII
Command
+n = data
byte[hex]
Description
Form feed FF 0C Print and return to standard mode.
Printed data is cleared from the data
buffer. The printing area set by ESC
W is reset to the default setting. See
ESC FF, ESC L, and ESC S
CAN CAN 18 Cancel print data in page mode. See
ESC L and ESC W.
Print data in
Page mode ESC FF 1B 0C Prints all buffered data in the printing
area. Printed data is not cleared from
the data buffer. ESC T and ESC W
values are not cleared. See FF, ESC
L, and ESC S.
Set absolute
print position ESC $ +n +m 1B 24 n m In Page mode with the starting
position (See ESC T) set to the top
left corner or the bottom right corner
this is a horizontal position but with
the starting position set to the top
right corner or the bottom left corner
this is a vertical position. See ESC \,
GS $, GS\.
Select Page
mode ESC L 1B 4C Must be received at the start of a
line. Settings of ESC SP, ESC 2,
ESC 3 have independent values in
page mode and standard mode. ESC
V, ESC a, ESC {, GS L, and GS W
while in page mode makes the
settings for standard mode but have
no affect while in page mode. The
printer returns to standard mode at
power on, reset, or ESC @ received.
See FF, CAN, ESC FF, ESC S, ESC
T, ESC W, GS$, GS \.