Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (Revision 20120510)
Page 34
character
size
1 to 8 times normal in either width or
height. Bits 0, 1, and 2 set the
character width multiplier. Bits 4, 5,
and 6 set the character height
multiplier. A value of 0 = Normal size.
Does not apply to HRI characters when
printing bar codes. See ESC !.
Test print
GS ( A 02hex
00hex +n +m
1D 28 41
02 00 +n
+m
n = 0 or 1 or 2 (00, 01, 02, 30, 31, or
32 hex). m=1 (01 or 31 hex) causes a
Hexadecimal dump print pattern. ).
m=2 (02 or 32 hex) causes a Printer
Status print pattern. m=3 (03 or 33 hex)
causes a “barber pole” print pattern.
Must be received at the start of a line.
A cut is performed following the print
test. The printer is reset following the
print test, even download characters or
bit image are erased.
Reverse
video
GS B +n
1D 42 +n
Bit 0 = 0 (default) turns off and bit 0 = 1
turns on reverse video printing. Does
not apply to bit image, user-defined bit
image, bar codes and the HRI part of
bar codes, or spaces skipped by HT,
ESC $, or ESC \ commands. Does not
affect the space between character
lines. Underline does not apply while
reverse video is enabled.
Set left
margin
GS L +n +m
1D 4C +n
+m
Set the left margin to dot position m x
256+
n
. Must be received at the start of
a line. Does not apply in Pase mode.
See GS W.
Set print
position to
the
beginning of
print line
GS T +n
1G 54 +n
n=0 (either 00 or 30hex) sets the print
position to the start of the print line
after deleting data in the print buffer.
n=1 (either 01 or 31hex) sets the print
position to the start of the print line
after printing data in the print buffer.
Cut
command
GS V m
1D 56 +m
+n
If m = 1 (either 01hex or 31hex) a cut is
performed and the
+n
byte must not be
sent. If m is a capital B (42hex) then
paper is fed for n dot lines and then a
cut is performed.
Set Right
Margin
GS W +
n
+m
10 57 +n
+m
Sets the print width to m x 256 + n
relative to the left margin. Must be
received at the start of a line. See GS
L.
Print raster
bit image
GS v 0 +m
+x1 +x2 +y1
+y2 +data
1D 76 30
m x1 x2
y1 y2 data
Error! Reference source not found.
OBSOLETE
– Use
GS (L,<Function 112 + 50>
instead
General Usage Print Commands
