Telpar MTP-1530II, Руководство пользователя, Страница: 33 / 83

Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (Revision 20120510) Page 33
Name Command
ASCII
Command
+n
= data
byte[hex]
Description
Forward
paper feed
for
n
dot
lines
ESC J
+n
1B 4A
+n
Print if needed then feed paper n dot
lines. Range = 0 to 255dec. If BM is
enabled, this command can feed paper
past the mark.
Select
character
font ESC M +n 1B 4D +n n=0 (00 or 30 hex) selects FontA
(12x24). n=1 (01 or 31 hex) selects
FontB (9x17). See ESC !
Select
International
character
set ESC R
+n
1B 52
+n
Select international character set. See
Section
Error! Reference source not
found.
–
Error! Reference source not
found.
+++ reprint section
Rotate print ESC V
+n
1B 56
+n n
= 1 (01 or 31 hex) Rotate the print 90
degrees clockwise.
n
= 0 (00 or 30 hex)
Cancel the rotation. Rotated characters
do not get underlined. Double wide
becomes double high and double high
becomes double wide. Not Page mode.
See ESC ! and ESC -.
Set relative
print position ESC \ +n +m 1B 5C n
m Set printing to current print po
(n+(m*256)). Ignored if specified
setting exceeds the printable area. See
Page mode.
Select
justification ESC a +n 1B 61 n n=0 (0 or 30 hex) Left justify. n=1 (01
or 31 hex) Center justify. n=2 (02 or 32
hex) Right justify. Normal mode only,
must be received at the start of a line.
See HT, ESC $, and ESC \.
Select paper
sensors to
output paper
end status ESC c 3 +n 1B 63 33
+n Bit 1 enables or disables the paper low
sensor. Bit 3 enables or disables the
paper out sensor. A value of 1 enables
and a value of 0 disables. Applies to
the parallel interface ONLY.
Select paper
sensor to
stop printing ESC c 4 +n 1B 63 34
+n Setting bit 0 or bit 1 high causes the
Paper Low sensor to be used as a
Paper Out sensor.
Panel
buttons
enable/disab
le ESC c 5 +n 1B 63 35
+n LSB = 0 Paper feed button is enabled.
LSB = 1 Paper feed button is disabled.
During a macro instruction standby the
feed button is always enabled but will
not feed paper.
Forward line
feed for n
character
lines
ESC d
+n
1B 64
+n
Print if needed then feed paper n
character lines. Range = 0 to 255dec.
Maximum amount of paper fed = 1016
mm (40”). Can feed past marks in BM
mode.
Select
Character
code table
ESC t
+n
1B 74
+n
See section 6.2 - Character Sets
Set/Reset
Inverted
print
ESC
{
+n
1B 7B +n LSB = 1, upside-down printing. LSB =
0, normal printing. This command must
be received at the start of a line to be in
effect for that line. Does not apply in
page mode.
Select GS ! +n 1D 21 +n Characters can be printed in sizes from