Telpar MTP-1530II Receipt Thermal Printer User Manual
MTP-1530II User Manual (
Rev.20120510
)
Page 16
The BM is detected at the position which the top edge of the BM comes into
approximately 0.02 to 0.08in (0.5 to 2 mm)
from the center of the BM sensor.
After detecting the BM, the BM is not detected for approximately 0.79in
(20mm).
The Figure above shows the BM Detection Position, Print Starting Position, and the Cutting Position
A:
1.32in (for straight paper-path model) 1.46in (for curled paper-path model)
33.6 mm (for straight paper-path model) 37.2 mm (for curled paper-path model)
B:
0.69in (for straight paper-path model) 0.83in (for curled paper-path model)
17.6 mm (for straight paper-path model) 21.2 mm (for curled paper-path model)
C:
Approx. 0.02in to 0.08in
Approx. 0.5 to 2mm
Black Mark Print Starting Position and Cutting Position:
At the factory, the print starting position and the cutting position are set to the print head position and the
cutter position respectively when the BM sensor detects the BM.
The print starting position and the cutting position can be changed with the
GS ( F
command.
Acceptable Width and Interval of Black Mark:
The width and interval of BM for which the printer operation is guaranteed are as follows:
BM width: 3 to 20 mm {0.12in} to {0.79in}
BM interval: 50 to 300 mm {1.97in} to {11.81in}
C
Paper
Feeding
Direction
A
B
Cutting Position
Print Starting Position
Approx.0.8 Inch
(2cm)
Paper