80
6 Controlling the device remotely by DTMF commands and text message
6.1 Remote control and status query by DTMF commands via phone call
The device can be controlled and status query can be performed after calling the number of the
SIM card installed into the device. In order to gain access to controls, the device password will be
requested or not, according to the setting configured in the “
Incoming call management
” section
for the given user phone number, which you can find in the “
Reporting channels
” menu. When
calling from a phone number which is not configured in the device, the password will always be
requested. The superadmin and admin passwords are both accepted. Thereafter,
the following commands can be used by pressing the phone’s keys:
List of DTMF commands
Command
Specification
Module response
9password#
Entering the device password
Password accepted: 3 beeps
Wrong password: 4 low-tone
beeps
0#
Disarm
3 beeps
1#
Arm
6 beeps
2#
Armed/disarmed status query
Disarmed: 3 beeps
Armed: 6 beeps
4#
GSM signal level query
The signal level will be indicated
by a number of beeps from 1 to 5
3RS#
Control the output(s)
R
: output (relay) number:
1
for the
IN6.R1 model,
1
to
2
for the IN4.R2
model
S
: output state:
0
= open,
1
= closed
Becomes open: 3 beeps
Becomes closed: 6 beeps
3R9#
Output state query
R
: output number:
1
for the IN6.R1
model,
1
to
2
for the IN4.R2 model
Open: 3 beeps
Closed: 6 beeps
Example:
1.
Incoming call management
setting: case of option “
Accept call and request password
”
and
superadmin
or
admin
password: 1234
:
a.
Activating output OUT1
:
Enter the device password:
91234#
(accepted: 3 beeps)
Activate output OUT1:
311#
(output OUT1 activated/closed: 6 beeps)
b.
State query on output OUT1
:
Enter the device password:
91234#
(accepted: 3 beeps)
State query on output OUT1:
319#
(if output OUT1 is activated/closed: 6 beeps)
2.
Incoming call management
setting: case of option “
Accept call and
don’t request
password
“:
Deactivating output OUT1
:
(3 beeps: password accepted)
310#
(output OUT1
deactivated/open: 3 beeps)
