1-800-433-4047 | 020222
Tell Manufacturing
1
INSTALLATION INSTRUCTION
LC1200/LC2400 SERIES LOCKS
DISASSEMBLE INSIDE LEVER
Leverset is set for 1 3 /4 " thick d oor - backset 2 3 / 4 "
Leverset is set for 1 3 / hick d oor - backset 2 3 / 4
HOW TO INSTALL THIS CYLINDRICAL LEVERSET
HOW TO INSTALL THIS CYLINDRICAL LEVERSET
1A:
Insert push pin into hole to
depress catch and remove the lever.
PUSH PIN
HOLE
INSIDE
LEVER
INSTALL LEVERSET TO DOOR
2A:
Insert latchbolt and secure
with combination screws.
LATCH
2B:
Place lock body into position. Make sure
that latch prongs engage chassis in housing,
and slide engages latch tail.
MOUNTING
SCREW
LOCK
BODY
INSIDE
SPRING
CAGE
2C:
Install inside spring cage , Screws
should be hand tightened all the way down
with a screwdriver.
Align the joint
blade with line.
INSIDE
LEVER
OUTSIDE
LEVER
KEY
PUSH PIN
LOCK BODY
CYLINDER
ASSEMBLY
INSIDE
ROSE
SLEEVE For 1 Hole
"
LATCH
OUTSIDE
TRIM
INSIDE
SPRING CAGE
SCREW POSTS
MOUNTING
SCREW
COMBINATION
SCREW
STRIKE
INSIDE
INSIDE
OUTSIDE
OUTSIDE
LEFT HAND
RIGHT HAND
LEFT HAND
REVERSE
BEVEL
RIGHT HAND
REVERSE
BEVEL
DOOR HANDS DETERMINED FROM OUTSIDE
DOOR HANDING
New Door Preparation
CENTER LINE
BASE
1"
2 1/8"
1/8
"
2 1
/4
2 3/8
/4
" or
2 3
"
"
-
-
-
-
5/
32
NOTCH
5/32
" wide
5/32
" deep
"
1 or 1-1/8
"
"
LOCK BODY
LATCH
PRONGS
LATCH
LATCH
TAIL
SLIDE
3/8
"
REMOVABLE
THRU BOLTS
1. Fold template over edge of
door and mark holes.
2. Drill a 2-1/8" hole.
3. Drill two 3/8" thru bolt holes
through face of door.(only if the
thru bolts are being used).
4. Drill a 1" hole in edge of door.
5. Cut 5/32" notches on
2-1/8" hole on both sides of door.
(very important if not using thr u bolts)
6. Mortise latch unit front
2-1/4" x 1-1/8" x 1/8" for 2-3/4" backset
or 2-1/4" x 1" x 1/8" for the optional 2-3/8" backset
1
2
HOW TO INSTALL A CYLINDRICAL LEVER SET
LEVERSET IS SET FOR 1 3/4” THICK DOOR - BACKSET 2 3/4”
