T. E. L. L. SOFTWARE
HUNGÁRIA KFT
46
7
Stopping the module properly
If you’d like to
normally switch off the IP Bridge module, keep the microswitch on the module pressed for 2-5
seconds, until LED1 turns orange, then release it. LED1 turns red then goes out.
When LED1 doesn’t lit
anymore, you can disconnect the power supply.
8
Restoring factory default settings
To reset the factory default settings, press and hold the button on the module for 8 seconds. The LED is lit
orange first then turns red. The module restores the factory default settings then restarts automatically.
Attention! During restore, also the network setting will be reset to the default DHCP.
9
General LED signals
Color
LED1
Red
Booting / shutdown in progress
Green
The system is ready
Orange
An error occured / On/Off is in progress
10
Technical specification
Supply voltage:
9-30V DC
Nominal current consumption:
200mA @ 12V DC
Maximum current consumption:
400mA @ 12V DC
Operation temperature:
-
20ºC
-
+70ºC
Maximum relay output load:
1A @ 12V DC
Dimensions:
130 x 69 x 19 mm
Weight:
200g (packed: 300g)
10.1
Generated telephone line specification
Line voltage:
48 V
Line current:
20 mA
Line impedance:
600 Ohm
Ringing voltage:
±50V (20 Hz)
Dial tone:
425 Hz
