T. E. L. L. SOFTWARE
HUNGÁRIA KFT
39
6.8
Remote modules
Figure 44. Remote module settings
You can add up to 6 remote IP Bridge modules to your device. You can use them for transparent serial data
transfer or for controlling the remote devices' output as an effect of a local event. The settings are the
followings (Figure 44.):
#:
The module’s index number
Name:
Unique name can be set for each module.
IP:
the modul
e’s
IP address (
If the remote module is not on the same network enter the router’s IP address and
the external port. It is also possible to add DNS instead of IP address. You need to configure the port forward in
the router!)
Port:
The device’s
https port
Username:
The username of device administrator.
Password:
The password of device administrator.
Test:
You can check your settings by clicking the test button.
Remote serial data transfer:
The following settings are required for the transparent serial data transfer.
Remote module:
Use the dropdown to select the remote module you’d like to associate with the device to use
it for serial data transfer. Besides the six modules, you can also select the
„
Receive only
”
option. In this case
the device only forwards data received from remote modules to its serial port. This can work with any number
of remote modules and they don’t
even need to be among the associated remote modules. Also, this option
must be selected if you use the module to program an alarm system through the IP Bridge Client program. If
you select from the six associated remote modules the device indicates the connection status.
