Telit GE864 and GC864
Product Description
80273ST10008A Rev. 3 - 10/02/06
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved
page 48 of 72
- In Command Mode (CM), some AT commands are provided to configure the Data Module
Internet stack and to start up the data traffic.
- In data traffic mode (Socket Mode, SKTM), the client can send/receive a raw data stream
which will be encapsulated in the previously configured TCP / IP packets which will be sent to
the other side of the network and vice versa. Control plane of ongoing socket connection is
deployed internally to the module.
5.1.3.1 Configuring the GPRS access
The GPRS access configuration is done by setting:
- the GPRS context number 1 parameters (see +CGDCONT command)
- the Authentication parameters: User Name and Password (see commands #USERID,
#PASSW)
5.1.3.2 Configuring the embedded TCP/IP stack
The TCP/IP stack behavior must be configured by setting:
- the packet default size (see command #PKTSZ)
- the data sending timeout (see command #DSTO)
- the socket inactivity timeout (see command #SKTTO)
5.1.3.3 Defining the Internet peer to be contacted
As last setting definition, the host to be contacted and on which port/protocol must be set:
- the socket definition (see command #SKTSET)
This command permits also to specify the host name instead of its IP address, if a host name is
given to the set command, then the module stores it as a host nick name. It is care of the module
user to guarantee that the host nick name provided corresponds to an existing internet peer.
If an host nick name has been given then, while opening the connection in response to the
AT#SKTOP command, the module will autonomously activate a GPRS connection and query its
DNS to obtain the IP address relative to the host nick name provided. This process of context
activation and DNS query may require a bit more time and requires that the GPRS network
coverage is good enough to permit data transfers.
Note that this setting command is not needed if the new #SKTD command is used.
5.1.3.4 Request the GPRS context to be activated
With the new command #GPRS you can activate or deactivate a GPRS context INDEPENDENTLY
from the TCP socket opening:
AT#GPRS=1 activates the context,
AT#GPRS=0 deactivates the context
Therefore with the AT#GPRS=1 command the module
- GE864 / GC864 activates the context previously defined with AT+CGDCONT
- GE864 / GC864 proceeds to the authentication with the parameters specified
