Telit Wireless Solutions BlueMod+S50, Руководство пользователя по оборудованию

Страница: 18 / 60

S50 Hardware User Guide
1VV0301505 Rev. 3
Page 18 of 60 2021-05-05
Not Subject to NDA
4.3.3. Serial Interface with UICP
A substantially saving of power during idle phases can be achieved (see when the UICP
protocol is used (refer to [2]). This protocol should be implemented on the host side as
well. Signals IUR-IN# and IUR-OUT# should be connected to the host and may be mapped
to DSR and DTR, if an RS232-style (DTE-type) interface is used (see Figure 7).
UART-TXD
GND
UART-RXD
CTS#
UART-RXD
UART-TXD
B
lu
eM
o
d
+
Sx
H
o
st
RTS#
CTS#
RTS#
IUR_OUT#
IUR_IN# IUR_OUT# / DTS
IUR_IN# / DTR
Figure 7: S50 Serial Interface Supporting UICP
If I/O line availability at the host side is extremely tight, 2 I/O lines could be saved by using
the following scheme. This would come at the cost of:
• The host is not allowed to enter sleep mode.
• The host must accept incoming data at all times and is not able to stop the
Sx sending data. This may be difficult to control for all scenarios and
adds the risk that data gets lost.
• The host does not implement UICP, but wake-up BT via GPIO.
UART-TXD
GND
UART-RXD
IUC_IN# / CTS#
UART-RXD
UART-TXD
B
lu
eM
o
d
+
Sx
H
o
st RTS#
CTS#
IUC_OUT# / RTS#
IUR_OUT#
IUR_IN# BM+Sx-WKUP
Figure 8: Five Wire Interface Supporting UICP