S50 Hardware User Guide
1VV0301505 Rev. 3
Page 15 of 60
2021-05-05
Not Subject to NDA
4.2.
Reset
S50 are equipped with circuitry for generating reset from two sources:
•
A reset is held active, when VSUP falls below the threshold of the brownout
detector (V
BOR =
1,2V … 1,7V), and is released when VSUP rises above V
BOR
+ V
HYST
.
The brownout detector also holds the reset active during power up, until VSUP >
V
BOR
.
•
A reset is generated, when VSUP is > V
BOR
and increases 300 mV or more, within
300 ms or less.
•
By holding pin B-1 (EXT-RES#) at
≤
VSUP*0,25V for t
HOLDRESETNORMAL
≥
0,2µs, an
external reset (
pin reset) is generated. This pin has a fixed internal pull-up
resistor (R
PU
= 11k
Ω
... 16k
Ω
). EXT-RES# may be left open if not used.
S50
E-6,F-6
VSUP
GND
+3V3
EXT-RES#
B-1
Reset-Switch is optional
Please Note: EXT-RES# of S50 has approx. 13k internal pullup.
Reset signal is optional
Host MCU
GPIO
VDD
Figure 4: S50 Example Reset
The following table shows the pin states of S50 during reset active. This pin
states are kept until hardware initialization has started.
Pin Name
State: S50
EXT-RES#
Input with pull-up
(1)
XL-IN
Input floating (disconnected)
XL-OUT
Input floating (disconnected)
UART-TXD
Input floating (disconnected)
UART-RXD
Input floating (disconnected)
UART-RTS#
Input floating (disconnected) with pull-up resistor 470k
Ω
(2)
UART-CTS#
Input floating (disconnected)
IUR-OUT#
Input floating (disconnected)
IUR-IN#
Input floating (disconnected)
GPIO[0:14]
Input floating (disconnected)
Содержание BlueMod+S50
Страница 1: ...BlueMod S50 HW User Guide 1VV0301505 Rev 3 2021 05 05 Telit Technical Documentation...
Страница 60: ......
