Telindus 1031, Руководство пользователя и справочник

Страница: 73 / 394

Telindus 1031 Router Chapter 5
User manual Basic configuration
63
5.4.1 Creating passwords in the security table
In order to avoid unauthorised access to the Telindus 1031 Router and the network you can create a list
of passwords with associated access levels in the security table. Do this using the
security attribute. Refer
to telindus1031/security on page 175 .
5.4.2 Correcting the security table
If you forgot your password or you forgot to create one with write and security access, then you can set
the
Load Default Configuration DIP switch. As a result, the Telindus 1031 Router reboots in its default
configuration. You can then retrieve the erroneous configuration and correct it.
To correct the security table, proceed as follows:
Step Action
1 Disconnect the power supply and open the housing as described in 3.3 - Opening and
closing the housing on page 32 .
2 Set DIP switch bank DS2 position 2 to off .
Refer to 3.1 - The Telindus 1031 Router motherboard on page 30 to locate this DIP
switch bank.
3 Replace the cover without fastening the screws and reconnect the power supply.
⇒
The Telindus 1031 Router reboots and loads the default configuration.
4 Retrieve the erroneous configuration:
5 Again, disconnect the power supply and open the housing.
6 Reset DIP switch bank DS2 position 2 to on .
7 Properly replace the cover as described in 3.3 - Opening and closing the housing on
page 32 and reconnect the power supply.
Step Action
1 Open a TMA session on the Telindus 1031 Router. Refer to 4.1 -
Managing the Telindus 1031 Router with TMA on page 34 .
2 Execute the
Load Saved Configuration
action.
3 Change the password and/or access rights in the security table.
4 Execute the
Activate Configuration
action.