56051701
–
Rev A
5
© 2019 Telguard
Getting Ready
The Telguard TG-PEM can be used with an activated Telguard TG-7 or TG-7FS communicator, or to activate the
communicator (if the firmware version supports the TG-PEM).
Note: Not all TG-7 series devices will have the minimum firmware version to work with the TG-PEM. In most cases,
firmware updates, if needed, will occur automatically during the activation process (please allow time for this to
happen). In other cases, TG-7 series firmware updates are available through the
portal. Finally, for
a TG-7FS when there is no DACT connection to the FACP, you will need to call Telguard Technical Support (1-800-229-
2326, option 9) for assistance.
Pre-Installation Checklist
Before attempting to install the TG-PEM in to the Telguard enclosure, please make sure you have all the proper parts at
the job site. The following items are shipped with each TG-PEM:
•
Telguard TG-PEM
•
Mounting bracket
•
Three mounting screws
•
Data cable
•
Quick Install Guide
You must also have certain installation test tools:
•
A screwdriver will be required to install the bracket and TG-PEM.
•
Solid or stranded electrical wire will be required to make power connections and to connect the Telguard
STC1 relay output to the FACP. The terminal strips can accommodate solid or stranded wire up to 18
gauge in size.
•
One 2.2kΩ resistor for
each supervised input to be used..
