TELGUARD CLASSIC
QUICK INSTALLATION GUIDE
MODELS: T-1630M, T-1630MA, T-1110M, T-1210M, T-3100UL
WIRING DIAGRAM
RJ31X
HOST C/C
PREMISE
PHONES
INCOMING
TELCO
SIGPATH0.VSD
2
3
4
5
6
7
T
GREEN
R
RED
R1
BROWN
T1
GREY
8
T1 T R
R1
J1
T1 T R
R1
J2
Telco Voltage
Measurement
House Phone
Current
Measurement
Dialer Current
Measurement
1
Internal Circuitry
Telco Dialer
T1 T R R1
TELGUARD
The TELGUARD has to be the first device on the incoming telco line. No
telco device can be in front of or in parallel with the TELGUARD or a Line Fault
condition will occur.
TELULAR CORPORATION
TEST MODE 55# PROGRAMMING
(MOTOROLA CELLULAR HANDSET REQUIRED)
1.
Power down unit and insert jumper
JP0
(upper left-hand corner of
PCB).
2.
Power up unit
without
the cellular handset being attached.
3.
Wait about 30 seconds for unit to completely power up.
4.
Attach cellular handset to the transceiver and power handset up.
5.
The handset will display randomly flashing numbers.
6.
Press the
#
key, the handset will display
US’
, now press
55 #
.
7.
The handset will display the System ID (SID) Number.
Typically, the only programming changes required are as follows:
Entry
01
5 Digit System ID.
Entry
03
10 Digit Cellular Phone Number.
Entry
06
2 Digit Group ID Mark.
The star key (
*
) advances you through the programming locations.
Numbers in
BOLD
are Factory Defaults.
NAM Location:
Example:
01
- System ID Number (SID) 00042 Press *
02
- A Option Byte
10101001
Press *
03
- 10 Digit Cellular Phone Number 941-910-9911 Press *
04
- Station Class Mark (SCM)
08
Press *
05
- Access Overload Class (AOC)
15
Press *
06
- Group ID Mark (GIM)
10 Press *
07
- Security Code
000000
Press *
08
- Unlock Code
123
Press *
09
- Service Level
004
Press *
10
- B Option Byte
00000101
Press *
11
- C Option Byte
00000000
Press *
12
- Initial Paging Channel (IPCH)
0333 or 0334
Press *
13
- Initial Paging Channel for System A
0333
Press *
14
- Initial Paging Channel for System B
0334
Press *
15
- Number of Dedicated Paging Channels
021
Press *
16
- D Option Byte
10111011
Press *
8. The handset will display “
/
“ in the upper right-hand corner of the
display.
9. Power down the handset and unplug it.
10. Put jumper
JP4 In
for B carrier. Put jumper
JP4 Out
for A carrier.
11. Remove jumper
JP0
and reset unit by powering it down and back up
again.
TELGUARD QUICK INSTALLATION GUIDE.DOC 05/21/98
Technical Support: 8:00AM – 5:00PM EST 800-229-2326
