Televes H30 CRYSTAL, Инструкция по эксплуатации

Страница: 24 / 40

H30 CRYSTAL
24
frequency.
-
Restore Powering
: On/Off. When you turn
your H30Crystal on, the meter will set the last
LNB configuration automatically whenever
this parameter is On.
- Language : English, Spanish.
- Units : dBµV, dBmV, dBm
-
Quality profiles
: Trunk, Tap, End Line,
Ground.
Different thresholds are available for different
testing locations.
- Analog Standard:
Selects the standard
for the analog channels and changes
automatically the audio carrier to a value
according to the selected standard.
- Audio Carrier:
4.5 MHz, 5.5 MHz, 6.0 MHz,
6.5 MHz.
- Volume
- Network:
Setup : Manual, Auto
When Setup Manual is selected, the user
must set the gateway.
IP
.
When Setup Manual is selected, the user
must set the IP.
DNS .
When Setup Manual is selected, the user
must set the DNS.
Gateway .
- Wi-Fi:
Allows to connect the H30 to a Wi-Fi
network.
Wi-Fi:
On, Off
Mode:
AP (Access Point), Client
Scan : When Wi-Fi is turned on and the
selected mode is Client, it shows a list of
all the found Wi-Fi networks.
As you can see in the image above, the list
shows the name of the Wi-Fi networks and
indicates if the network is open or restricted,
as well as the protection access type.
To access to a restricted network, you must
enter the password using and
To verify the password, find a red square
behind the last character of the password
and press
-
Time and Date
:
Set current time (hour and minutes) and
date (day of the month, month and year).
- Energy:
Auto suspension
Auto shutdown
- Update firmware: See section Firmware
update
- Reset configuration: Resets the
H30Crystal
to factory settings
- Licenses:
Shows a list with all the licenses
included in your H30Crystal
- About SW
- About HW