User Guide -
EZMesh Full Duplex Mesh Network Access Point
The other question regarding MAC addresses is a little bit complicated. Each
MeshAP has many networking interfaces, which has ONE or MORE MAC
addresses associated with each interface. This is why you may see MAC addresses
differ from the MAC address on label.
VLAN Tag
Access Mode
Untagged (no VLAN ID) frames entering (ingress) the Ethernet port will be
accepted, and transit the network with the VLAN ID and priority specified in the
VLAN ID field. Tagged (with a VLAN tag) frames entering the Ethernet port will
be dropped. The VLAN tag will be removed from frames leaving (egress) the
Ethernet port.
Setup Access Mode
Step 1. Login
to the
Ethernet/VLAN
Step 2.
Check
“Access” radio button under the
VLAN Ethernet Mode
Step 3.
Click
Save Setting and Apply
Trunk and Native VLAN Mode
Trunk and Native VLAN - Both untagged and tagged (VLAN IDs and priority
included) frames entering the Ethernet port will be accepted. Untagged frames will
be on Native or Management VLAN. Tagged frames will pass through the mesh
network unchanged. Egress (outgoing) frames will exit the Ethernet port unaltered.
If the frame leaving the Ethernet port contains a VLAN tag, it will be transmitted
with that same tag. If the frame leaving the Ethernet port does not contain a VLAN
tag, the frame will be transmitted without a tag.
TELETRONICS INTERNATIONAL, INC.
- 41 -
