Teletrac CTO7, Руководство по установке

Страница: 11 / 20

Sterling LT Series- Power, Diagnostics,
and PTO Connections
Power Connections: As the 9-pin Deutsch connector provides
12 volt constant power, only the ignition sense requires an
external connection. The ignition feed is accessed from the
rear of the ignition switch, as show at top right. Many of the
wires are pink, thus a digital multimeter must be used to
verify the correct wire.
PTO Connection:
While there is a PTO switch on the dash, it
does not provide an adequate output for the TM470J. The
best source for PTO is from the passenger’s side relay panel.
Carefully remove the panel and connect to the
positive
output of relay #13, which is for the transmission. As nearly
all of the wires are pink, a digital multimeter must be used to
determine the correct wire. This wire will provide a positive
output, which must be inverted to a negative signal with the
provided relay, and then connected to the
grey wire on the
TM470J wiring harness.
Diagnostic Connection:
The 9-pin Deutsch plug is located on
the bottom of the dash, facing downwards, directly below
the ignition switch. Carefully remove the OEM port and
replace with the J-bus y-adaptor.