Teletec international Minicom 6000, Руководство пользователя

Страница: 15 / 87

12 • SETUP
Making Connections
Pull the plastic tab out of the battery compartment on the bottom of
the Minicom 6000 before you plug in the AC adapter. The Ring
Indicator will not work if the tab is not removed and the batteries are
not fully charged.
The AC adapter supplies electricity to the Minicom 6000 and charges
the batteries. You should leave the adapter plugged in at all times. New
batteries will be fully charged after 24 hours. Once fully charged,
batteries will provide about 90 minutes of normal use without
electrical connection. For more information on using battery power,
see
About the Batteries on page 69.
Step 3
Step 2
Step 1
Step 4
The illustration above shows how to set up for direct connect. This
means the Minicom 6000 is plugged directly into the telephone line.
In direct connect, you can dial from the keyboard and use Auto-Answer.
If, for some reason, you cannot plug a telephone line into the
Minicom 6000, you can connect by putting a telephone handset in the
acoustic cups. See
Acoustic Calling and Answering on page 19 for
more information.
The Minicom 6000 comes set up for tone dialling, which is used by
most telephone lines. If your line uses pulse dialling, make sure the
minicom is set up for that. For more information, see
Setting Pulse
Dialling on page 55.