Telestream PRISM MPI2-10, Руководство пользователя

Страница: 95 / 302

Configure the Instrument
Configure and Select Signal Inputs
97
PRISM MPI2-10-MPX2-10 User Manual
Note:
You must save the program configuration to update the programs in the audio
bars and loudness meter.
Select DOLBY
Note: Dolby D Plus and E are available in SDI and 2022.
a. Select DOLBY .
b.
In the Dolby Audio Channel Pair menu, select the audio channel pair that
contains Dolby audio.
Dolby audio in the selected channels are then decoded. Only Dolby D/D Plus/E
decode is supported.
c.
Select
Save
and close the menu.
Note:
Audio programs configured in the Program Configuration menu are used to
select a program for measurement by the Loudness application, to display audio bars
in the Audio application, and to monitor with headphones. When all the channels are
unassigned, all the channels are treated as stereo pairs. The audio programs in the
Dolby E stream are automatically set up based on the Dolby E metadata.
Note:
The number of audio streams and channels determines the content and order
of audio channels embedded in the AUX OUT.
Note: If the audio bars are flashing in the audio display, or sounds are garbled or the
wrong pitch, it is possible that the audio input configuration is not set up correctly.
Check the IP address, port, and payload type from the IP session display and make sure
to select the correct number of audio channels. A guideline for the number of audio
channels (assuming 24bit 48khz audio) is approximately 1 to 1.5 Mb/s per channel.
See the IP Status Bitrate column.
Note:
To receive only audio, disable the video stream.