Telestream PRISM MPI2-10, Руководство пользователя

Страница: 91 / 302

Configure the Instrument
Configure and Select Signal Inputs
93
PRISM MPI2-10-MPX2-10 User Manual
Note:
With Seamless Switching, a reconstructed output stream is created from the
two input streams. The reconstructed stream is used downstream for various display
tiles like Picture. The buffer size to absorb the packet reception time difference
between Path1 and Path2 is 10ms. The output stream reconstruction does not work
properly for streams on Path1 and Path2 with skew greater than 10ms. This error
makes Picture tiles show the wrong image.
8. Configure the Video (2110-20) stream tab:
a.
Select the
Video
tab.
b. Move the Enable Video slider to Enabled to begin configuration.
c.
Enter the information in SFP Port, Source Addr, Source Port, Destination Addr.,
and Destination Port for each video stream.
d.
Set the RTP Payload Type between 96 and 127.
e.
Set the Packet Read Schedule (PRS) to Gapped, Narrow Linear, or Wide Linear to
correctly measure the CMAX and VRX buffer measurements in the IP graphs.
Note:
The PIT Histogram can be used to determine if the signal is a gapped, narrow-
linear, or wide-linear stream.
f.
Set the TR Offset, which defines the timing reference offset of the sender for
network delays. Select Auto to provide an offset based on the current video
standard.
g.
Select the Gamma Curve and Color Gamut settings for the video stream. See
Select Video Settings
for information on available Gamma and Gamut selections.
9.
Configure the Audio (2110-30) stream tab: