TeleSite QuickSilver DV202S, Руководство по установке и эксплуатации

Страница: 27 / 42

TX001-00-00 Rev 101 QuickSilver DV202S Video Transmitter Installation
••••
19
AUDIO BD Internal Audio Card
1. Unpack the card from the bag. Refer to
Figure 22.
2. Disable power and lift the cover from the
Transmitter by removing the four screws from
the sides.
3. Locate the Audio Card’s slot on the board.
Either of the 2 available slots can be used.
4. Hold the Audio Card at 45
°
angle to the
surface and line up the notch on the card with
the tab on the slot. The Audio Card can only
be installed one way. If necessary, reverse
the card.
5. Push the card down into the socket and allow
it to swing to an upright position. When the
latches have snapped into place, the card is
installed.
6. Replace the cover and power-on the
Transmitter.
Note: The Transmitter will automatically
recognize the card upon power-on.
32 MEM Transmitter Memory
The Transmitter stores incoming pictures into its
memory. The 32 MEM memory is a standard 32
Mb EDO, 60 ns, SIMM type card. It is located at
the front of the unit as shown in Figure 23. This
card can be removed and replaced in the event of
its failure. Simply unsnap the latches and allow
the card to tilt at a 45
°
angle to lift out.
Figure 22
Audio Card Installation
Figure 23
Memory Card Installation