TeleSite QuickSilver DV202S, Руководство по установке и эксплуатации

Страница: 15 / 42

TX001-00-00 Rev 101 QuickSilver DV202S Video Transmitter Installation
••••
7
I-MODEM Modem
The installation of this Modem should be performed only if the X-566 (POTS/PSTN) is not being used. The
installation of this Modem is done in 2 subsections, Configuration and Operation. It is necessary to configure
the ISDN Modem, using a PC type computer, before attempting to connect to, and use with, the Transmitter.
Note: Review manual for Modem to verify that all requirements for ISDN line service are met before
attempting to configure Modem.
Note: Modem must be configured on-site and connected to actual ISDN line to be used before connecting to
Transmitter.
Configuration
1. Unpack Modem and power supply.
Connect power supply to Modem. Do
not apply power yet. Refer to Figure 7.
2. Connect Modem to computer by
attaching one of the DB-25 connector
ends on provided cable to Modem’s
serial port labeled TO DTE. Connect
the remaining connector end to
computer’s serial port. If the computer
has more than 1 serial ports available,
COM2 should be used.
Note: If the computer is equipped with a
DB-9 connector for its serial port, use the provided 25 to 9 pin adapter included with the Modem.
3. Connect one end of telephone cable (RJ-45 modular connector) to ISDN socket on Modem and the
remaining end to the ISDN wall socket.
4. Power-on Modem and verify that Modem Power LED illuminates solid. In addition, verify that Modem
initializes by verifying the following LEDs:
a) All LEDs should illuminate briefly to verify that they function.
b) DSR LED should illuminate solid to verify that Modem is ready for operation.
c) LNK LED should illuminate at a fast blinking rate. This state verifies that Modem has detected a valid
ISDN line and is searching for more identity information.
Note: If Modem fails to initialize, refer to Modem manual for error codes and troubleshooting.
5. Power-on computer and go to Microsoft Windows operating system.
6. Refer to Configuration section of Modem manual and follow instructions specific to computer operating
system. When complete, the following items should be complete:
a) correct ISDN Modem driver is installed.
b) correct ISDN telephone numbers are entered.
c) correct ISDN switch type is entered.
d) correct ISDN SPID numbers are entered.
7. Software will respond with a successful link message when a successful connection is made. If a
connection error message appears, refer to Modem manual Troubleshooting section.
8. Power-off the computer and ISDN Modem.
9. Disconnect DB connector from computer. Attach 25 to 9 pin Adapter to the end, if required.
Figure 7
ISDN Modem Configuration