TX001-00-00 Rev 101 QuickSilver DV202S Video Transmitter
Installation
••••
5
CRU
Refer to Figure 5.
1. Unpack CRU and power supply. Connect
power supply to CRU. Do not apply power
yet.
2. Place CRU on top of Transmitter.
3. Connect all cameras to CRU, starting at
CAM 1 position.
4. Connect coaxial jumper cable between
VIDEO OUT on CRU and CAM 6 on
Transmitter.
5. Connect 25 pin Ribbon Cable Assembly
between side of Transmitter and CRU at the
DB-25 sockets. If cable has more than 2
connectors, cut off the remaining connectors
with a scissor.
6. Open CRU by removing 4 side screws and
locate DIP switch SW1. Define the Module
number as in Table 1. Set DIP switch to
correct CRU address as in Table 2.
Note: All units are configured, from the factory
as Module number 1.
7. Reassemble
CRU.
8. Power-on Modem, Transmitter and CRU. All
power-on LEDs should illuminate. Stacked
CRUs must be powered-on from the top
down. For example, Modules must be
switched on in the order #6, #5, #4, #3, #2,
#1. If Modules are not powered-on in the
correct order, the cameras attached to those
specific Modules may not appear in the
software’s camera list.
Note: Connect consecutive CRUs starting from
CAM 6 to CAM 1 as shown in Table 1. In
addition, verify that each CRUs internal
DIP Switch is configured as specified in
Table 2.
9. Calculate the number of CRUs required for
the number of video inputs on hand as
shown in Table 1. Stack additional CRUs as
shown in Figure 6.
10. Set the DIP switch address for each
additional CRU as shown in Table 2.
Note: Failure to configure additional CRUs as
shown can result in improper operation of
the system.
Figure 5
CRUQuick Installation
CAMERA ADD-ON
MODULE
NUMBER
CAMERA INPUT
NUMBER ON
TRANSMITTER
TOTAL SYSTEM
VIDEO INPUTS
VIDEO CABLE
LENGTH in (mm)
1
6
13
5 (127)
2
5
20
10 (254)
3
4
27
15 (381)
4
3
34
20 (508)
5
2
41
25 (635)
6
1
48
30 (762)
Table 1
CRU Configuration
CAMERA ADD-ON
MODULE
NUMBER
DIP SWITCH 1
(SW1)
DIP SWITCH 2
(SW2)
DIP SWITCH 3
(SW3)
DIP SWITCH 4
(SW4)
1
ON
ON
ON
ON
2
OFF
ON
ON
ON
3
ON
OFF
ON
ON
4
OFF
OFF
ON
ON
5
ON
ON
OFF
ON
6
OFF
ON
OFF
ON
Table 2
CRU DIP Switch Configuration
Содержание QuickSilver DV202S
Страница 2: ......
Страница 4: ......
Страница 8: ......
Страница 14: ...6 Installation TX001 00 00 Rev 101 QuickSilver DV202S Video Transmitter Figure 6 Transmitter Quick Installation...
