TeleSite QuickSilver DV202S, Руководство по установке и эксплуатации

Страница: 12 / 42

4
••••
Installation TX001-00-00 Rev 101 QuickSilver DV202S Video Transmitter
Installation
The installation of QuickSilver is a multi-step process. This section will detail the installation of QuickSilver
using a Quick Installation or Detailed Installation sub-section. Both sub-sections detail the installation of the
Transmitter with the PSTN (X-566) modem. Since several types of modems can be used, refer to the later
subsections referring to the ISDN (I-MODEM) when using an ISDN type modem.
Installation can be summarized with the following steps:
1. Unpack the components and prepare the remote site for hardware installation.
2. Install, wire and configure all components at the remote site.
3. Verify the power-on condition of all components at the remote site.
4. Install and configure the software on the Receiver at the local site.
5. Proceed to the Operation section and verify proper connection and installation to the remote site.
Quick Installation
For experienced installers, follow these
steps for fast installation. Refer to Figure
4.
DV202S Transmitter/X-566
Modem
1. Unpack Transmitter and power
supply. Connect power supply to
Transmitter. Do not apply power yet.
2. Connect all cameras to Transmitter,
starting at CAM 1 position. If
necessary to loop any cameras out,
open cover and remove terminating
jumper from coincident input. Use a
BNC type T connector to loop input.
3. Unpack Modem and power supply.
Connect power supply to Modem.
Do not apply power yet.
4. Connect Modem to Transmitter as
follows:
a) Attach 25 pin cable side to
Modem.
b) Attach 9 pin cable side to
Transmitter’s
Communication Port #1.
5. Connect telephone line modular
connector to LINE IN socket on
Modem.
6. Power-on Modem and Transmitter.
Power-on LED should illuminate.
Yellow LED should blink for a few seconds and then remain off. If this LED remains blinking or is on solid,
there is a problem with modem initialization or unit itself. Recheck all connections and power-on condition
of modem.
Note: For connection to other devices or more installation details, refer to the Detailed Installation sub-section.
Figure 4
Transmitter/Modem Quick Installation