Telenetics MIU56, Руководство пользователя

Страница: 16 / 22

Industrial Modem MIU56 User Guide
MIU56Robert Way Page 16 2/28/2003
#O1 Disconnects if terminal buffer overflows
#O2 Disconnects if line buffer overflows
#O3 Disconnects if either buffer overflows
#PIN=n Pin Number where n is the pin number
#R0 Remote Control Mode
#V0 Command and S Register verifier off
#V1 „ Command and S Register verifier on
%B0 „ S0=0 setting after AT&F
%B1 S0=2 setting after AT&F
%C0 Compression disabled
%C1 MNP 5 compression enabled
%C2 V.42bis data compression enabled
%C3 „ V.42bis data compression enabled with fallback to MNP 5
%Dn Set disconnect delay to n seconds (default %D0)
%E0 Disable auto-retrain
%E1 „ Enable auto-retrain
%E2 Automatic Speed Stepping
%H0 „ Use B setting for initial MNP 10 connection speed
%H1 Initial connection is made at 1200 bps (MNP 10)
%H2 Initial connection is made at 4800 bps (MNP 10)
%H3 Initial connection is made at 9600 bps (MNP 10)
%H9 Use B setting for connection but do not upshift (MNP 10)
%K0 „ CTS operates normally
%K1 CTS off during dial and handshake
%L0 Report current received signal level (-dBm)
%Ln Set transmit level (n=11 to 19; -11dBm to -19dBm)
%M0 „ Mode LEDs indicate connection speed
%M1 Mode LEDs indicate line quality, V.42/MNP errors & flow ctrl
%N0 „ Standard Baud Rates
%N1 Standard to 14400 then 20800, 31200, 41600 and 62400
%N2 Standard to 38400 then 51200
%P0 „ CONNECT message appears before DCD asserted
%P1 CONNECT message appears after DCD asserted
%Q Report current line quality (EQM) (0=perfect)
%R0 „ &R command determines state of CTS
%R1 CTS always follows RTS (not reset by &F)
%R2 CTS follows DTR when offline (not reset by &F)
%S0 „ DSR is not overridden
%S1 DSR mimics the state of DTR (not reset by &F)
%T0 „ DCD always follows state of carrier
%T1 DCD is always high (not reset by &F)
%U0 „ Standard error correction response codes
%U1 V.42 response codes when V.42 connection established
%U2 V.42 response codes for V.42 connections, MNP 2,4,10 compression
%W0 „ Disable welcome message
%W1 Send message specified by *W to remote modem after connect
\A0 MNP block size = 64
\A1 MNP block size = 128
\A2 MNP block size = 192
\A3 „ MNP block size = 256
\Bn Send Break sequence to remote modem (default \B3)