Telenetics MIU56, Руководство пользователя

Страница: 14 / 22

Industrial Modem MIU56 User Guide
MIU56Robert Way Page 14 2/28/2003
M4 Speaker on during dial, answer, retrain or rate change
O1 Enter On-line state and force communication retrain (V.22bis and V.32bis only)
O2 Retrain, donÕt go on-line (V.22bis & V.32bis)
O3 Change line speed to 4800 bps (V.32 & V.32bis)
O4 Change line speed to 7200 bps (V.32 & V.32bis)
O5 Change line speed to 9600 bps (V.32 & V.32bis)
O6 Change line speed to 12000 bps (V.32 & V.32bis)
O7 Change line speed to 14400 bps (V.32 & V.32bis)
P Pulse dialling
Q0 „ Modem returns response codes
Q1 Modem does not return response codes
Q2 Modem does not return RINGING or response codes when answering
R9 9600 bps (locked terminal speed - no autobaud)
R14 14,400 bps (locked terminal speed - no autobaud)
R19 19,200 bps (locked terminal speed - no autobaud)
R28 28,800 bps (locked terminal speed - no autobaud)
R38 38,400 bps (locked terminal speed - no autobaud)
R57 57,600 bps (locked terminal speed - no autobaud)
R115 115,200 bps (locked terminal speed - no autobaud)
R230 230,400 bps (locked terminal speed - no autobaud)
Sn? Display value in S Register ÔnÕ
Sn=x Place ÔxÕ in S Register ÔnÕ
T „ Tone dialling
V0 Numeric response codes
V1 „ Verbal response codes
W0 CONNECT message reports the terminal speed
W1 CONNECT message reports the terminal speed
W2 „ CONNECT message reports the line speed
X0 Basic response codes (codes 0-4,8)
X1 Extended response codes (codes 0-5,8,10-12,30-40,60-62)
X2 Extended response codes (codes 0-6,8,10-12,30-40,60-62)
X3 Extended response codes (codes 0-5,7,8,10-12,30-40,60-62)
X4 Extended response codes (codes 0-7,10-12,30-40,60-62)
X5 „ Extended response codes (codes 0-7,10-13,30-40,60-62)
X6 Extended response codes (codes 0-5,7-8,10-13,30-40,60-62)
Zn Restore configuration profile n (n=0,1,2,3)
&B0 8 bit character length
&B1 9 bit character length
&B2 10 bit character length
&B3 11 bit character length
&B4 „ 10 or 11 bit character length determined by autobaud
&C0 DCD signal always asserted
&C1 „ DCD signal responds to remote modem
&C2 DCD signal always on, pulses low on disconnect
&C3 DCD asserted during voice session
&D0 Ignore DTR
&D1 Return to Local command state if DTR goes low
&D2 „ Hangup & return to Local Com if DTR goes low, disable auto-answer until DTR
asserted
&D3 Initialise with values in &Y profile if DTR goes low
&F0 Restore factory defaults