Teledyne TS-C2500, Руководство пользователя

Страница: 126 / 191

124

Operational Reference Genie_TS_Series GigE Vision Camera
Acquisition Start Cmd AcquisitionStart Start image capture using the currently selected
acquisition mode. The number of frames captured is
specified by AcquisitionMode feature. (WO)
1.00
Beginner
Acquisition Stop Cmd AcquisitionStop Stops the Acquisition of the device at the end of the
current frame unless the triggerFrameCount feature
is greater then 1. (WO)
1.00
Beginner
Acquisition Abort Cmd AcquisitionAbort Aborts the acquisition immediately. This will end the
capture without completing the current Frame or
aborts waiting on a trigger. If no acquisition is in
progress, the command is ignored. (WO)
1.00
Beginner
Transfer Control TransferControlMode Sets the method used to control the transfer.
Basic Basic Basic mode ensures maximum compatibility but does
not allow for control of the transfer flow.
User Controlled UserControlled Manual mode allows maximum control of the transfer
flow.
1.10
Expert
Transfer Mode TransferOperationMode Sets the operation mode of the transfer.
Continuous Continuous Blocks are transferred continuously until stopped with
the TransferStop command.
Multi Block MultiBlock The transfer terminates after the transition on
TransferBlockCount or before on a user request.
1.10
Expert
Transfer Block Count TransferBlockCount Specifies the number of Data Blocks the device must
stream during the next transfer. 1.10
Expert
Transfer Queue Current
Block Count transferQueueCurrentBlockCount Returns the current number of blocks in the transfer
queue. 1.10
Expert
Transfer Start TransferStart Starts the streaming of data Block(s)to another
device. 1.10
Expert
Transfer Stop TransferStop Stops the streaming of data Block(s)to another
device.
1.10
Expert
Transfer Abort TransferAbort Aborts the streaming of data Block(s)to another
device. 1.10
Expert
Device Registers
Streaming Start
DeviceRegistersStreamingStart Announces the start of registers streaming without
immediate checking for consistency.
1.00
Invisible
Device Registers
Streaming End DeviceRegistersStreamingEnd Announces end of registers streaming and performs
validation for registers consistency before activating
them.
1.00
Invisible
Device Feature
Persistence Start DeviceFeaturePersistenceStart Available and automatic with GenAPI 2.4.
Called first before a camera configuration feature
save with third party SDK if it is not GenAPI 2.4
compliant.
1.00
Invisible
Device Feature
Persistence End
DeviceFeaturePersistenceEnd Available and automatic with GenAPI 2.4.
Called after a camera configuration feature save with
third party SDK if it is not GenAPI 2.4 compliant.
1.00
Invisible
Register Check DeviceRegistersCheck Performs an explicit register set validation for
consistency.
1.00
Invisible
Registers Valid DeviceRegistersValid States if the current register set is valid and
consistent.
1.00
Invisible
Acquisition Buffering
All acquisitions are internally buffered and transferred as fast as possible to the host system. This
internal buffer allows uninterrupted acquisitions no matter of any transfer delays that might occur
(such as acquisition frame rates faster that the Gigabit Ethernet link or the IEEE Pause frame ).
Only when the internal buffer is consumed would an Image Lost Event be generated.
Note that the internal image buffer is a reserved minimum of 256MB, which is increased up to
512MB dependent on other functions not loaded or used (such as FFC gain and offset coefficients).
Additionally the maximum number of individual image buffers is 64k, if such images are small
enough to all fit in available memory.