Teledyne T360, Руководство по эксплуатации, Страница: 69 / 358

67
4.
OPERATING INSTRUCTIONS
To assist in navigating the analyzer’s software, a series of menu trees can be
found in Appendix A-1 of this manual.
NOTES
The flow charts appearing in this contain typical representations of the analyzer’s display during the
various operations being described. These representations may differ slightly from the actual display of
your instrument.
The ENTR button may disappear if you select a setting that is invalid or out of the allowable range for that
parameter, such as trying to set the 24-hour clock to 25:00:00. Once you adjust the setting to an
allowable value
, the ENTR button will re-appear.
4.1. OVERVIEW OF OPERATING MODES
The T360 software has a variety of operating modes. Most commonly, the
analyzer will be operating in
SAMPLE mode. In this mode, a continuous read-
out of the CO
2
concentration is displayed on the front panel and output as an
analog voltage from rear panel terminals, calibrations can be performed, and
TEST functions and WARNING messages can be examined.
The second most important operating mode is SETUP mode. This mode is used
for performing certain configuration operations, such as for the DAS system, the
reporting ranges, or the serial (RS-232/RS-485/Ethernet) communication
channels. The
SET UP mode is also used for performing various diagnostic tests
during troubleshooting.
Figure 4-1: Front Panel Display
07272B DCN6552