Teledyne T200, Руководство по эксплуатации, Страница: 100 / 425

Setup Mode Menus Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual
98
5.7. SETUP

COMM: COMMUNICATIONS PORTS
This section introduces the communications setup menu; Section 6 provides the setup
instructions and operation information. Press SETUP>ENTR>MORE>COM to arrive at
the communications menu.
Concentration field
displays all gases.
SAMPLE RANGE=500.0 PPB NOX= XXXX
<TST TST> CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
Figure 5-2. SETUP
– COM Menu
5.7.1. ID (MACHINE IDENTIFICATION)
In the SETUP>MORE>COM menu press ID to display and/or change the Machine ID,
which must be changed to a unique identifier (number) when more than one instrument
of the same model is used:

in an RS-232 multidrop configuration (Sections 3.3.1.8)

on the same Ethernet LAN (Section 6.5)

when applying MODBUS protocol (Section 6.7.1)

when applying Hessen protocol (Section 6.7.2)
The default ID is typically the same as the model number, e.g., 0200 for the Model
T200; it may also be 0 . Press any button(s) in the MACHINE ID menu (Figure 5-3) until
the Machine ID in the Parameter field displays the desired identifier.
06858E DCN7057