Teledyne T101, Руководство по эксплуатации, Страница: 40 / 375

Getting Started Teledyne ML – T101 Operation Manual
36
3.3.3. CONNECTING THE STATUS OUTPUTS
The analyzer’s status outputs are accessed through a 12-pin connector on the analyzer’s
rear panel labeled STATUS. They are used to interface with a device that accepts closed-
contact digital inputs, such as programmable logic controllers (PLC’s).
C
o
n
n
e
c
t to
I
n
te
rn
a
l
G
ro
u
n
d
o
f M
o
n
ito
ri
n
g
STATUS
1 2 3 4 5 6 7 8 D
+
SY
ST
E
M
O
K
HI
G
H RANG
E
CO
NC V
AL
ID
Z
E
RO
CAL
S
P
A
N CAL
DI
AG
NO
S
T
IC M
O
DE
Figure 3-9. Status Output Connector
NOTE
Most PLCs have internal provisions for limiting the current the input will draw. When connecting to
a unit that does not have this feature, external resistors must be used to limit the current through
the individual transistor outputs to ≤50mA (120 Ω for 5V supply).