Teledyne T101, Руководство по эксплуатации, Страница: 150 / 375

Remote Operation Teledyne ML – T101 Operation Manual
146
There are two methods to activate control inputs. The in5V available from the “+”
pin is the most convenient method (Figure 4.18). However, to ensure that these inputs are
truly isolated, a separate, external 5 VDC power supply should be used (Figure 4.19).
CONTROL IN
A B C D E F U
+
LO
W
S
PA
N
Z
E
R
O
S
PA
N
Figure 5-2. Control Inputs with Local 5 V Power Supply
CONTROL IN
- +
5 VDC Power
Supply
LO
W
S
PA
N
Z
E
R
O
S
PA
N
A B C D E F U
+
Figure 5-3.Control Inputs with External 5 V Power Supply
5.1.2. REMOTE OPERATION USING THE EXTERNAL SERIAL I/O
5.1.2.1. Terminal Operating Modes
The Model T101 can be remotely configured, calibrated or queried for stored data
through the serial ports. As terminals and computers use different communication
schemes, the analyzer supports two communicate modes specifically designed to interface
with these two types of devices.
•
Computer mode is used when the analyzer is connected to a computer
with a dedicated interface program such as APICOM. More information
regarding APICOM can be found in later in this section or on the Teledyne
ML website at http://www.teledyne-ml.com/software/apicom/.
•
Interactive mode is used with a terminal emulation programs such as
HyperTerminal or a “dumb” computer terminal. The commands that are
used to operate the analyzer in this mode are listed in Table 5-3.