Teledyne Q-Lite, Инструкция по установке и эксплуатации, Страница: 66 / 242

Q-Lite Satellite Modem Installation and Operating Handbook
6-33
Table 6-37 defines the serial M&C RS485 interface pinout when IP-Remote is selected
(refer to Chapter 11 for full connector pinouts).
Pin Signal
Name
Direction RS485:
IP – Remote Mode
Shield/Gnd Shield/Gnd
3 Master-B + to modem TX-B
4 Slave-B + from modem RX-B
5 Shield/Gnd
6 Slave-A - from modem RX-A
9 Master-A - to modem TX-A
Table 6-37 Serial M&C Interface RS485 Pinout (IP Remote Mode)
Range: 1 to 255; step size: 1
Description: This is the RS485 address that is assigned to the modem’s serial M&C
interface.
Table 6-38 Serial M&C Interface RS485 Address
Range: 110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
76800, 115200
Description: This sets the baud rate associated with the modem’s serial M&C
interface.
Table 6-39 Serial M&C Interface Baud Rate
6.2.6.7 Modem Identity
The Modem identifier is a user-assigned text string that is typically used to uniquely
identify the modem, satellite service or location. It is displayed as the ID field on the left-
hand-side of every web page.
6.2.6.8 Submit Mode
Submit mode is used when reconfiguring modems (particularly remote modems) in order
to simplify the process of synchronising configuration changes at both ends of the link in
order not to break the link while changing multiple control parameters. When submit
mode is active, a Submit button appears on the web user interface as shown in
Figure 6-
11 .