M1xx/M2xx/M3xx Series Camera Installation addendum
Important installation update
Since the publication and printing of the manual supplied with your camera, the mounting procedure for the camera
has changed, following additional installation feedback from Raymarine's dealer network.
The following mounting
procedure MUST be followed when mounting your camera, and supersedes the mounting procedures detailed
in the printed manual supplied with your camera.
Installation fixings
The following fixings are supplied with your camera.
This list supersedes the fixings information provided in the
printed manual supplied with your camera.
All other supplied parts remain the same as those listed in the manual.
1.
Flat nuts (M6, A4 stainless) x2.
Must only be used to assist in winding the studs into the camera’s base.
2.
Dome nuts (M6, A4 stainless) x3.
If needed, fit to studs to cover exposed ends. Do NOT use with riser.
3.
Threaded stud (M6, 60 mm, A4 stainless) x3.
4.
Flat washers (M6, A4 stainless) x3.
5.
Nyloc nuts (M6, A4 stainless) x3.
Applying Loctite
Before inserting the threaded studs into the base of the camera, you MUST first apply “Loctite 243” threadlocker (or
equivalent), to all 3 studs.
Important:
If the supplied threaded studs are not long enough to accommodate all the fixings and the thickness of
the mounting surface, obtain longer replacement
marine-grade stainless steel
M6 threaded studs (e.g. 316/A4).
1. Clean and de-grease the 3 supplied threaded studs and the camera baseplate's tapped threads.
2. Allow to dry before proceeding to the next step.
3. Apply generous amounts of "Loctite 243" threadlocker (or equivalent) to each of the studs.
4. Insert the threaded studs into the camera's baseplate immediately, ensuring sufficient thread protrudes, to allow the
fitting of washer and nuts.
If necessary, fix the supplied flat nuts (x2) (temporarily) to the studs, to assist you
in winding the studs fully into the camera's threads. Discard flat nuts once done.
5. Remove any excess Loctite.
Any remaining Loctite must be thoroughly cleaned from the studs and base.
6. Allow the Loctite on the threaded studs to cure for 24 hours, before proceeding to the next step.
Note:
If using the riser to mount the camera, do NOT allow any Loctite to come into contact with the riser, as
the Loctite may damage the riser material.
Document number: 82429 (Rev 1)
AA;27716;2022-03-31T15:13:23
Date:
04-2022
