Teledyne 2103, Инструкция по установке и эксплуатации

Страница: 19 / 94

2103 Modem Module
Section 2 Preparation and Installation
2-5
2.4.1 Modem Cable
Connection
After you have installed the 2103 on the stack, you need to attach
the modem cable so the module can be connected to a phone line.
Remove the connector cap from the 5-pin circular modem cable
connector on the right hand side of the 2103. Attach the modem
cable to the connector (Figure 2-1), and then connect the other
end of the modem cable to a standard telephone jack (USOC
RJ-11C).
Figure 2-1 Connecting the Modem Cable
2.4.2 Connection Without
the Modem Cable
If desired, the 2103 can be connected to a standard telephone line
by attaching the telephone line cable to a connector that mates
with the 2103’s 5-pin circular modem cable connector (Figure
2-2). Be sure that you have a water tight seal on your wire con-
nections.
For your reference, the modem cable uses a 5-pin amphenol
socket, MS3106A-5S.
Figure 2-2 2103 Modem Cable Connector