TeleDart GmbH & Co. KG, Obere Heide 8, 67368 Westheim, Germany
3.
Handling and use
First use
Make yourself familiar with all operation elements of your applicator before you attempt
to test the applicator and to go into practice.
TeleDart Guns have varying settings to allow you to adopt the applicator to your
individual requirements.
Before shipment, we test all TeleDart applicators at a distance of 15 m (16.41 yds)
using a
TeleDart Dart Syringe (TD03-11/ TD05-13/TD03-16)
.
For your training we recommed to use the supplied traing darts. For training purposes
it is not necessary to pressurize the dart syringe. If you have to work with other dart
volumes please proceed in the same way. Note all pressure values in the pressure
table which is part of your manual.
Assembling
Slide-in the barrel as far as it goes. Take care that the sight is on your right hand side.
As soon as the barrel has reached its position, turn the barrel a quarter (90°) to the left
until the guiding pin situated at the barrel retainer ring locks.
•
Individual Adjustments (gun)
Adopt the cheek piece and the shoulder support at a position at which you can shoot
comfortably.
•
Inserting of the CO²-cartridge
Unscrew the cartridge holder and insert a CO²-cartridge. Tighten up the cartridge
holder until the cartridges is tapped.
Only replace open cartridges if they are completely empty. Further all safety advices
marked on the packing of the CO²-cartridges are valid. TeleDart does not take any
liability for damages and injuries caused by improper handling of CO²-cartridges.
•
Safety
Check if the safety device of the trigger is on safe. The turning knob must be turned to
the upper position (Pos. “S”).
•
Pressurizing
Airpump:
The pressure regulation knob must be in “0”- Position. Latch the hose of the airpump
with the hose- connector. To unlatch the airpump the locking sleeve of the hose
connector has to be pushed back until the hose unlatches.
CO2:
The applicator is pressured if you turn the pressure regulation knob maxium one
quarter (90°) in direction of the „+“-position. Observe the manometer and release the
