Telecor VS1, Инструкция по установке, настройке и эксплуатации

Страница: 34 / 281

20 Hardware
HARDWARE CONFIGURATION & INSTALLATION
This section contains instructions and figures to configure and install the VS1 phone system
hardware.
The Telecor VS1 telephone system can be either rack mounted or wall mounted. Each PEU comes
with brackets for a wall mount and rack mount setup. Mounting hardware for other components is
ordered depending if a wall mount or rack mount setup is used. Prior to mounting the equipment, the
PEUs must first be considered to support CO Lines or Station Extensions.
Configuring the PEU 250
The Model 250 PEU has 16 ports, each of which can be configured as a CO or Station port. It is
recommended that the PEU 250 serve as the first PEU on the system, as it is labeled with ports 1 to
16. Ports are addressed sequentially by the TVS. When configuring more than one PEU, verify that
each port is correctly identified before changing switch settings.
To configure the PEU 250:
1. Use the pushbutton switches next to each port jack to set the port as a CO Line or Extension.
•
CO Line = button in
•
Extension = button out
Note: If your current software version is prior to 2.9, only the first eight ports on the PEU Model
250 are configurable as CO lines.
Note: In order for Caller ID to work on Ports 1 - 8, Port 1 must be set as a CO Port. In order for
Caller ID to work on Ports 9 – 16, Port 9 must be set as a CO Port.
Front view of
PEU 250
Cut-Over Functioning on the PEU 250
The PEU 250 provides power failure cut-over functioning for up to four analog CO lines by routing
the CO lines directly to station sets on the VS1 telephone system. A Port from 1 through 4
configured as a CO Line will cut over to an associated Port from 5 through 8, respectively, if
configured as an Extension.
Port configured as
CO Line
Cuts over to Port if configured as
Extension
1 5
2 6
3 7
4 8