9.3 S how settings
1. Press the
Function
button 3 times
The function LED 3 lights (green).
2. Press the
Select
button.
The relay LEDs 1–4 indicate the current settings according to the following
table:
Relay LED Color
Off
On
Indicates
LED_R1
red
○
Discontinuous transmitting mode
●
Continuous transmitting mode
LED_R2
red
○
Custom ID not enabled
●
Custom ID enabled
LED_R3
red
○
Configuration ID not enabled
●
Configuration ID enabled
LED_R4
red
○
Frequency scan on
●
Frequency scan off (fixed frequency)
After approximately 10 seconds, the receiver will automatically exit "Show
Settings"mode and return to normal operation.
9.4 Operating modes
This receiver is provided with two
Operating modes
as standard (a and 255). For
other
Operating modes
, contact your representative for assistance.
NOTE: If
Operating mode
255 has been selected, it is not possible to change the
Operating mode
from the receiver.
9.4.1 S H O W / C H A N G E O PERA T I N G MO DE
RISK OF UNINTENDED EQUIPMENT OPERATION
Do not perform this action when the receiver is in a session with another
transmitter. The radio communication may be interrupted or broken.
Failure to follow these instructions could result in death, serious injury,
or equipment damage.
1. Press the
Function
button 4 times.
Function LED 4 lights (orange).
.
The relay LEDs indicate the current
Operating mode
according to the table
IM-PN-RX107-CERT-01pre4
43
PRELIMINARY
