Tektronix VM5000 Series, Быстрый старт Руководство пользователя

Страница: 44 / 94

Getting Acquainted with Your Instrument
Procedure for Taking Measurements
1. Set the input signal format parameters using Con fi guration > Format .
2. Select one or more measurements to take using Con fi guration > Measurements .
3. Set the measurement run operations using Con fi guration > Operation .
4. Select the Run button to take and view the measurements.
5. Save measurement results using Utilities > Generate Report .
Con fi guring the DUT — Option VGA
To perform measurements on the DUT, you must provide an appropriate video signal to the VM Series system. You
accomplish this by displaying a bitmap
fi le on the PC in which the DUT is operating. The preferred bitmap fi le, when
taking multiple measurements, is the Matrix signal. If you need to take only one measurement, you can use a full- fi eld test
pattern rather than the Matrix signal. All the necessary Matrix signal and full- fi eld test pattern bitmaps required to test for
compliance to the VESA Test Procedure – Evaluation of Display Graphics Subsystems (Version 1 Rev. 1), are located
on the
PC Bitmap Graphics Test Signal Files CD-ROM.
1. Set the resolution and refresh rate of the
DUT to the required values.
2. On the PC containing the DUT, display
the contents of the
PC Bitmap Graphics
Test Signal Files CD-ROM.
3. Display the contents of either the Matrix
or Full Field folder.
If you plan to take multiple
measurements, open the Matrix
folder.
If you plan to take only one
measurement, open the Full Field
folder and select the appropriate test
pattern using the following table.
30 VM Series Video Measurement System Quick Start User Manual