GPS7 GPS Synchronization and Timecode Module
After you select a digit, use the up (
▲
) or down (
▼
) arrow button to change
the value of the digit. Repeat for each digit as required for your date and time.
Press the
ENTER
to con
fi
rm the change.
NOTE.
When the DST event occurs, the scheduled offset will be added to the time
zone offset, and the DST schedule will be cleared. This allows for a new schedule
to be set up for any time in the future.
NOTE.
VITC may have DST shift already applied. To avoid duplicating DST
shifts, disable the DST SCHEDULER if the time of day reference has DST applied.
PROGRAM TIME Submenu
Use this menu to set the initial value for the Program Time counter. The following
fi
gure shows the PROGRAM TIME submenu.
Figure 3-65: GPS7 module PROGRAM TIME submenu
APPLY.
Press the
ENTER
button to immediately apply the initial program time
entered in the SETUP parameter below.
SETUP.
Press the
ENTER
button, and then use the left (
◄
) or right (
►
) arrow
button to select a digit in the Program Time counter to change. An underline
character appears under the selected digit. The date and time digits take the
following form: HH:MM:SS.
After you select a digit, use the up (
▲
) or down (
▼
) arrow button to change
the value of the digit. Repeat for each digit as required. Press the
ENTER
to
con
fi
rm the change.
3–128
TG700 TV Signal Generator Platform User Manual
Содержание TG700
