Tektronix MSO54, Руководство программиста

Страница: 799 / 1026

Commands listed in alphabetical order
this command speci fi es the lower limit of the range. (Use the command
TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:HIVALue to set the upper limit of
the range.) The default is all X’s (don’t care). The bus number is speci fi ed by <x>.
Conditions Requires the SR-ENET Triggering and Analysis application.
Group Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:VALue <QString>
TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:VALue?
Related Commands TRIGger:{A|B}:BUS:B<x>:ETHERnet:CONDition
TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:OFFSet
TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:SIZe
TRIGger:{A|B}:BUS:B<x>:ETHERnet:DATa:HIVALue
Arguments
QString is a quoted string where the allowable characters are 0, 1, and X.
The allowable number of characters depends on the setting for size (using
TRIGger:A:BUS:B<x>:ETHERnet:DATa:SIZe). The bits speci
fi ed in the
quoted string replace the least signi fi cant bits, leaving any unspeci fi ed upper
bits unchanged.
Examples
TRIGger:A:BUS:B1:ETHERnet:DATa:VALue "00001000"
sets the binary
data to trigger on to 00001000, assuming the quali fi er is set to
LESSthan,
MOREthan, EQual, UNEQual, LESSEQual
or
MOREEQual,
and
DATa:SIZe
is set to 1 byte.
TRIGger:A:BUS:B1:ETHERnet:DATa:VALue "00001000"
sets the lower
limit of the range to 00001000, assuming the quali fi er is set to
INrange
or
OUTrange
, and
DATa:SIZe
is set to 1 byte.
TRIGger:{A|B}:BUS:B<x>:ETHERnet:IPHeader:DESTinationaddr:VALue
When the Ethernet trigger condition is set to
IPHeader
, this command speci fi es
the value of the 32–bit destination address that is to be used in the trigger (along
with the source address and protocol value). The IP destination address is a
standard IP address such as 192.168.0.1. The default is all X’s (don’t care). The
bus number is speci
fi ed by <x>.
Conditions Requires the SR-ENET Triggering and Analysis application.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-783