Tektronix MSO54, Руководство программиста

Страница: 793 / 1026

Commands listed in alphabetical order
TRIGGER:A:BUS:B1:CAN:FD:ESIBIT?
might return NOCARE, indicating that
CAN FD packets are not being fi ltered based on the ESI bit value.
TRIGger:{A|B}:BUS:B<x>:CAN:FRAMEtype
This command sets the frame type (data, remote, error or overload) to be used
when triggering on a CAN bus signal. The trigger condition must be set to
FRAMEtype (using
TRIGger:{A|B}:BUS:B<x>:CAN:CONDition ).
B<x>
is the
bus number.The bus number is speci fi ed by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:CAN:FRAMEtype
{DATa|REMote|ERRor|OVERLoad}
TRIGger:{A|B}:BUS:B<x>:CAN:FRAMEtype?
Arguments
DATa
speci fi es a data frame type.
REMote
speci fi es a remote frame type.
ERRor
speci fi es an error frame type.
OVERLoad
speci fi es an overload frame type.
Examples
TRIGGER:A:BUS:B1:CAN:FRAMETYPE DATA
sets the CAN trigger frame type
to DATA.
TRIGGER:A:BUS:B1:CAN:FRAMETYPE?
might return
:TRIGGER:A:BUS:B1:CAN:FRAMETYPE DATA
indicating the frame type is data.
TRIGger:{A|B}:BUS:B<x>:CAN:IDenti fi er:MODe
This command sets the addressing mode (standard or extended format) to be
used when triggering on a CAN bus signal. The trigger condition must be set to
IDANDDATA or DATa (using
TRIGger:{A|B}:BUS:B<x>:CAN:CONDition ).
The bus number is speci fi ed by <x>.
Conditions Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
MSO54, MSO56, MSO58, MSO58LP Programmer 2-777