Tektronix Keithley SourceMeter 2470, Справочное руководство

Страница: 663 / 995

2470 High Voltage SourceMeter Instrument Reference Manual Section 14: TSP command reference
2470-901-01 Rev. A /
May
2019 14-23
bufferVar.fillmode
This attribute determines if a reading buffer is filled continuously or is filled once and stops.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Restore configuration
Instrument reset
Power cycle Configuration script User-defined buffer:
buffer.FILL_ONCE (0)
defbuffer1:
buffer.FILL_CONTINUOUS (1)
defbuffer2:
buffer.FILL_CONTINUOUS (1)
Usage
fillMode = bufferVar .fillmode
bufferVar .fillmode = fillMode
fillMode Fill the buffer, then stop:
buffer.FILL_ONCE
or
0
Fill the buffer continuously:
buffer.FILL_CONTINUOUS
or
1
bufferVar The name of the reading buffer, which may be a default buffer (
defbuffer1
or
defbuffer2
) or a user-defined buffer
Details
When a reading buffer is set to fill once, no data is overwritten in the buffer. When the buffer is filled,
no more data is stored in that buffer and new readings are discarded.
When a reading buffer is set to fill continuously, the oldest data is overwritten by the newest data after
the buffer fills.
When you change the fill mode of a buffer, any data in the buffer is cleared.
Example
reset()
testData = buffer.make(50)
print(testData.fillmode)
testData.fillmode = buffer.FILL_CONTINUOUS
print(testData.fillmode)
Create a reading buffer named
testData
, configure the instrument to make three measurements, and store
the readings in the buffer. Print the fill mode setting for the
testData
buffer.
Output:
0
Set fill mode to continuous.
Print the fill mode setting for the
testData
buffer.
Output:
1
Also see
buffer.delete() (on page 14-9)
buffer.make() (on page 14-12)
bufferVar.clear() (on page 14-18)
print() (on page 14-99)
printbuffer() (on page 14-100)
Reading buffers (on page 6-1)
Remote buffer operation (on page 6-25)