Tektronix BERTScope, Быстрый старт Руководство пользователя

Страница: 23 / 42

Installation
Power off the instrument
1. Press the front panel power button to
turn the instrument off.
The green power indicator on the button
will turn off.
2. Disconnect the power cord from the rear
of the instrument to completely remove
power from the instrument after it shuts
down. NEW DRAWING HERE
BERTScopePC Software
The BERTScope PC software provides for PC control of BERTScope Clock Recovery instruments and the Digital
Pre-Emphasis Processor (DPP) instruments that are being operated as stand-alone instruments (not connected directly to a
BERTScope bit error rate tester).
With the BERTScopePC software installed on a Windows PC, and the stand-alone instrument connected to the PC via the
standard USB interface, the BERTScopePC software initiates installation of the appropriate driver and provides a user
interface allowing control of all DPP or CR functions. The user interface provided for each instrument is similar to the
BERTScope bit error rate tester.
Included in the installation is the BERTScope Remote Client application which provides for remote access to the
BERTScopePC application. Also included is the CR
fi rmware update tool.
This software must be installed on a PC running the Windows XP Professional operating system.
Insert the BERTScope PC disk in the disc drive of the PC and follow the on-screen instructions to install the software.
After the software is installed, start the software from the Start menu by selecting Start > BERTScope > BERTScope PC UI
(or one of the other selections in the menu).
CR125A, CR175A, CR286A Quick Start User Manual 5