Example 2: Set up the Error Detector
Example 2: Set up the Error Detector
This example uses the same setups as Example 1. It provides information on how to set up the Error Detector to accept
differential CML signals and to make a bit error rate measurement.
NOTE.
Before continuing, make sure that you have the high-quality coaxial cables as describe in Example 1. (See page 13,
Connect the front panel cables.)
1.
Touch
View
on the control console and
then select
Detector
to display the
Detector view.
2.
Touch the
Data
button, select
Interface
Mode
, and then select
Differential
.
3.
Touch the
Data
button again, select
Logic Family
, and then select
DIFF-CML/SCFL
.
16
Tektronix BERTScope Bit Error Rate Analyzers Quick Start User Manual
